340 Guides authored 41 other people completed this guide.

Disconnect the Lightning connector assembly

like Touch ID, or can you just replace it without and issue?Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

If it doesn't, use the point of your spudger to pry up and transfer the cable from your old Lightning assembly to the new one.Compare your new replacement part to the original part. Unscrew the logic board

?Sorry about that!

Remove the top left grounding clip Remove the display assembly You can use some high concentration isopropyl alcohol to help clean the surface.Before removing the adhesive backing, make sure the Lightning connector assembly is correctly positioned by aligning the hole in the flex cable with the screw post.

It’s actually shown in the 3rd image in the last step.

Community

However, ensure the eject tool is properly aligned beforehand as to not damage the eject mechanism inside the phone.When reinserting the SIM card, ensure that it is in the proper orientation relative to the tray.A thin rubber gasket around the SIM card tray provides water and dust protection. FREE …

A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.Power off your iPhone before beginning disassembly.Remove the two 3.5 mm pentalobe screws on the bottom edge of the iPhone.Opening the iPhone's display will compromise its waterproof seals. Tool used on this step: I have done a variety of repairs on iPhones (screens, batteries, etc.)

For best results, replace the two adhesive patches before installing your Lightning connector assembly.Check to see if your new part comes with an antenna converter cable.

iPhone Lightning Dock - White - Next Gallery Image; iPhone Lightning Dock - White.